Assembly Technology – Electronics Manufacturing and RF Characterization

© Fraunhofer FHR
Examples from the PCB assembly process: SMD assembly (1), vapor phase soldering (2), die bonding (3), and optical inspection (4).

Fraunhofer FHR has specialized infrastructure for the development, fabrication, and characterization of electronic assemblies. The facilities cover the entire process chain, from PCB assembly and microelectronic packaging and interconnection technologies to RF characterization. This enables the efficient development and validation of prototypes, demonstrators, and small production runs for radar, communication, and sensor systems.

SMD Assembly and Soldering Technology for Prototypes and Small Production Runs

PCB assembly begins with the Fritsch printALL stencil printing system, which precisely applies solder paste and adhesives to printed circuit boards. SMD components are subsequently placed using the Fritsch MP904 pick-and-place system, which is particularly suited to prototypes, engineering samples, and small production runs. Reflow soldering is performed using the IBL SV260 vapor-phase soldering system. Its uniform heat transfer ensures high-quality solder joints while minimizing thermal stress on sensitive components. These systems are used, for example, in the development of radar assemblies, RF modules, and electronic sensor systems.

Microelectronic Interconnection Technologies for RF Assemblies

For applications where conventional SMT processes reach their limits, such as the integration of monolithic microwave integrated circuits (MMICs), specialized chip integration technologies are available. The Westbond 7372E die bonder enables the precise placement and bonding of bare semiconductor dies on substrates or printed circuit boards. Electrical interconnections are subsequently created using the Westbond 7476E wire bonder. Fine gold or aluminum wires are used to establish electrical connections between the die and the substrate. These processes are particularly relevant to microwave and millimeter-wave circuits, RF modules, MEMS components, and aerospace applications. They also provide an important technological basis for advanced packaging concepts and the heterogeneous integration of electronic systems.

Quality Assurance and Failure Analysis for Printed Circuit Boards

High-performance microscopy systems are available for inspection, rework, and failure analysis. The Vision Engineering Lynx EVO stereo zoom microscope provides high-quality three-dimensional visualization of electronic assemblies and supports assembly, inspection, and rework operations. The Keyence VHX-7000 digital microscope complements these capabilities with high-resolution imaging, precise measurements, and documentation of microscopic structural and manufacturing defects. This enables detailed inspection of features such as wire bonds, PCB traces, and solder joints, providing valuable information for optimizing development and manufacturing processes.

RF Characterization

The MPI TS300-PCB probe station enables direct measurement of electronic assemblies on wafers or populated printed circuit boards following calibration using calibration substrates. Using probes, the system provides precise electrical contact with very small test points and conductive structures without the need to solder additional RF connections. This enables efficient characterization and validation of RF circuits, antenna structures, and signal paths. Typical applications include radar and microwave systems as well as advanced sensor and microelectronics solutions.

Integrated Process Chain

From the Fritsch printALL, Fritsch MP904, and IBL SV260 to the Westbond 7372E and Westbond 7476E, as well as the Vision Engineering Lynx EVO, Keyence VHX-7000, and MPI TS300-PCB, Fraunhofer FHR provides integrated infrastructure for the development, fabrication, testing, and characterization of microelectronic systems. This integrated process chain enables new components to progress efficiently from initial prototypes to small production runs and undergo application-oriented validation, preparing them for subsequent transfer to industrial applications.